Water Quality Assessment and Variation Trends Analysis of the Min River Sea-Entry Section, China Abstract In order to further understand the status of the water quality of Min River’s sea-entry section, the index systems for water environmental quality assessment was built based on twenty evaluation parameters including dissolved oxygen (DO), permanganate index (CODMn), chemical oxygen demand (CODCr), biochemical oxygen demand (BOD5), ammonia (NH3-N), total phosphorus (TP), and total nitrogen (TN). Water environmental quality of Min River’s sea-entry section in 2015–2017 was evaluated by utilizing the entire-array-polygon synthesis illustration method, accompanied by the time-dependent trend analysis. The results demonstrated that the water environmental quality of Min River’s sea-entry section was between the levels I and II of the Environmental Quality Standards for Surface Water (EQSSW, GB3838-2002) in 2015–2017, indicating a generally good water quality. The water quality was affected by both natural factors (such as temperature, rainfall, and runoff) and human factors and had a tendency to deteriorate at the duration of 2015–2017. The research results are of great significance for further understanding of the discharge of pollutants from the Min River basin and will be a strong support for the scientific decision-making of marine management in Fujian Province.

Influence of Heavy Metals on Seed Germination and Seedling Growth of Wheat, Pea, and Tomato Abstract Experiments were conducted under lead (Pb), cadmium (Cd), and copper (Cu) exposure to observe germination and seedling growth of wheat (Triticum aestivum L), pea (Pisum sativum), and tomato (Solanum lycopersicum L.). Metals were applied in five concentrations (20, 65, 110, 175, and 220 ppm) and Hoagland solution was used to feed the seedlings. Irrespective of the tested crop seeds, copper revealed maximum effect (51.2%) on germination followed by lead (47.5%) and cadmium (35.3%). Tomato seeds were most sensitive in germination stage followed by pea and wheat. In seedling stage, tomato also showed highest sensitivity to both Cd and Cu. However, pea seedlings showed higher tolerance to Pb and wheat seedlings had the highest tolerance to both Cu and Cd. Toxicity and tolerance of metals was found to vary with crops and growth stages. Higher transfer of metals (Pb, Cd, and Cu) in wheat seedling indicates higher risk of food chain contamination when grown in polluted soil. Higher mobility and uptake of Cd in tomato and wheat seedlings even under lower concentration of exposure needs further study.

Paracetamol Degradation Performance and Mechanisms Using Microwave-Assisted Heat-Activated Persulfate in Solutions Abstract A microwave (MW) heat-activated the persulfate (PS) process was employed to treat paracetamol (PAM) in wastewater, and the powder-activated carbon (PAC) be used is used as a catalyst to accelerate this reaction process. The PAM added (100 mg) to the solution was nearly completely removed within 70 min, and the PH, temperature, PAC, and PS dosage have great influence on the degradation process; the total organic carbon (TOC) removal rate reached 98%. The PAC1 still had a good catalytic effect after being reused six times. The radical mechanism was investigated to determine the type of dominant active species involved in PAM degradation. Sulfate radicals (\( {\mathrm{SO}}_4^{-\bullet } \)) were the dominant oxidizing agent for PAM degradation under acidic conditions. The degradation mechanism was proposed based on the PAM degradation intermediates, which were identified using ultra-high-performance liquid chromatography coupled with linear trap quadrupole orbitrap mass spectrometry. Three types of possible reaction pathways for PAM were identified as follows: including hydroxylation of the benzene ring, amine group oxidation at the benzene ring, and amine (HN–C=O) functional group N–C bond cleavage.

A Chemical Time Bomb: Future Risks of Microplastics Abstract Despite the controversy, the ecological risk of microplastics research has increased sharply from only one in 1966 to 495 in 2018, according to Web of Science with microplastics as keyword. To date, an upward trend of global microplastics mass emission was confirmed by many environmental scientists. The ocean is the ultimate destination of land-based microplastics sources; therefore, most of efforts were concentrated on microplastics in aquatic environment. In this brief article, the global release of microplastics and flux into the ocean in the recent decade were estimated roughly. The plastics fragmentation in the marine environment only accounted for 22% of total microplastics release (assuming defined emission rate per capita and fragmentation rate of plastics). Future research is needed for microplastics generation and retention in the terrestrial system, especially indoor environments. The accumulated microplastics over the environmental self-purification capacity certainly increases stress for the marine, freshwater and terrestrial ecosystem.

The Effect of Temperature Oscillations and Sediment Texture on Fecal Indicator Bacteria Survival in Sediments Abstract Fecal indicator bacteria (FIB) inhabiting stream sediments have become a concern with regard to recreational and irrigation water quality. Sediments contain higher concentrations of E. coli and other FIB than the overlying water column. The objective of this work was to evaluate the effect of temperature oscillations on the populations of both E. coli and enterococci in sediments and the water column. The study was conducted in a microcosm system with flow-through chambers representing a small stream with two different sediment textures. Bovine manure was freshly collected and mixed with both clayey and sandy sediment. Temperatures within the chambers oscillated from 17° to 28 °C which is representative of a diurnal summer temperature range for Maryland; the control chambers were kept at 22 °C. The effect of temperature oscillations differed depending on the sediment texture. Bacterial populations in the sandy sediment immediately increased before net die-off began. Conversely, in the chambers with the clayey sediments, there was no immediate increase in concentrations in the oscillation chambers as compared to the controls. There were significantly higher populations of both E. coli and enterococci within the oscillation sandy texture chambers compared to the control constant temperature chambers; that was not the case in the clayey sediment chambers. The die-off rates in the sandy sediments were greater than those in the clayey sediments; in the latter, bacteria populations remained almost constant throughout the experiment. Temperature oscillations should be simulated in experiments designed to estimate and compare inactivation rates for fecal indicator bacteria in sediments for future inferences on microbial water quality.

Spatial and Temporal Evolution Characteristics of Drought in Yunnan Province from 1969 to 2018 Based on SPI/SPEI Abstract The objective of this article is to describe the effect of precipitation and temperature on the drought characteristics of Yunnan province in China. The rainfall and temperature data from 10 national meteorological stations in Yunnan province during 1969 to 2018 were used to investigate the spatial and temporal evolution of drought in Yunnan province and the difference of drought index based on Standardized Precipitation Index (SPI) and Standardized Precipitation Evapotranspiration Index (SPEI) at nearly 50a different time scales. The results showed that Yunnan province had a frequent alternation of drought and flood, and the larger the time scale, the gentler the SPI and SPEI changes. The recent 50a drought mainly occurred in 1980–1982, 1988–1990, 2003–2007, and 2010–2015, and there was continuous drought and the duration was prolonged. The changes of SPI and SPEI showed a downward trend in different seasons. The linear slopes of SPI and SPEI in spring, summer, autumn, and winter were − 0.0064, − 0.0088, − 0.0057 and − 0.0.0111, respectively, and the drought trend was the most serious in winter. Continuous spring drought occurred in 2009–2010 and 2012–2014. The SPEI values in 2009–2010 and 2012–2014 were − 0.80, − 0.64, − 0.75, − 1.23, and − 1.17, respectively. The spatial distribution of drought frequency in Yunnan province was greatly different, and its distribution rule was more in the north and east, less in the south and west. The drought frequency in Zhaotong (northeast Yunnan) was the highest at 36.53%, the drought frequency in Deqin and Lijiang (northwest Yunnan) were 33.11% and 33.28%, and the drought frequency in Kunming (central Yunnan) Lincang, Lancang, and Simao (southwest Yunnan) were 29.35%, 30.73%, 32.77%, and 28.35%, respectively. This study provided a scientific basis for revealing the spatial and temporal variation rules, evolution trends, regional drought, and drought impact assessment and risk management of drought in Yunnan province.

Soil Heavy Metal(loid) Pollution and Phytoremediation Potential of Native Plants on a Former Gold Mine in Ghana Abstract This study investigated the soil pollution level and evaluated the phytoremediation potential of 25 native plant species on a former gold mine-tailing site in Ghana. Plant shoots and associated soil samples were collected from a tailing deposition site and analyzed for total element concentration of As, Hg, Pb, and Cu. Soil metal(loid) content, bioaccumulation factor (BAFshoots), and hyperaccumulator thresholds were also determined to assess the current soil pollution level and phytoextraction potential. The concentration of As and Hg in the soil was above international risk thresholds, while that of Pb and Cu were below those thresholds. None of the investigated plant species reached absolute hyperaccumulator standard concentrations. Bioavailability of sampled metal(loid)s in the soil was generally low due to high pH, organic matter, and clay content. However, for Cu, relatively high bioaccumulation values (BAFshoots > 1) were found for 12 plant species, indicating the potential for selective heavy-metal extraction via phytoremediation by those plants. The high levels of As at the study site constitute an environmental and health risk but there is the potential for phytoextraction of Cu (e.g., Aspilia africana) and reclamation by afforestation using Leucaena leucocephala and Senna siamea.

Role of AM Fungi in the Uptake and Accumulation of Cd and Ni by Luffa aegyptiaca Abstract Sponge gourd (Luffa aegyptiaca) was grown in pots with and without inoculation with two arbuscular mycorrhizal (AM) fungi, viz., Glomus macrocarpum and Glomus monosporum singly and in combination. Seven-day-old plants were treated with 18.9 μg Cd g−1 soil and 155.4 μg Ni g−1 soil alone and in combination. At 90 days old stage, dry weight of root, shoot, and fruit; uptake of heavy metals in root, stem, leaves, and fruits; percent mycorrhizal root colonization; and spore number in the root zone were determined. When applied singly, the uptake of Cd and Ni in host plants was enhanced more effectively by G. monosporum than G. macrocarpum. The larger proportion of Cd uptake in uninoculated host was retained in the roots but in inoculated plants (with both Glomus sp.), major amounts of the Cd were translocated to the above ground parts including fruits. The leaves were the main sinks of Ni in inoculated plants. The overall tissue burden of both heavy metals in the host was enhanced relatively more effectively on association with G. monosporum as compared with G. macrocarpum. The uptake of Cd was relatively higher in plants treated with both the metals and both the AM fungi. Despite the relatively higher uptake of both the heavy metals in inoculated plants, the host dry weight was significantly higher compared with uninoculated plants. The percent mycorrhizal root colonization of the host by both AM fungi was higher in plants grown without either of the heavy metals. The combined application of both the heavy metals reduced the spore density in the root zone soil of host. The results show that the AM fungi enhanced the uptake of Cd and Ni by the host but alleviated the toxicity by promoting plant growth.

The Azo Dye Degradation and Differences Between the Two Anodes on the Microbial Community in a Double-Anode Microbial Fuel Cell Abstract The anode configuration determined the performance of power generation and contaminant removal in microbial fuel cell (MFC). In this study, double anodes were constructed along an up-flow MFC for mitigating the suppression of refractory organic azo dye Reactive Brilliant Red X-3B and increasing the power output. Results revealed that high concentration of X-3B suppressed the power generation of MFC. The maximum power density decreased from 0.413 to 0.161 W/m3, and the inner resistance rose from 448 to 698 Ω. However, double anodes weakened the suppression of X-3B to the current generation. Compared with single anode, the attenuation of MFC current decreased from 48 to 40%. Meanwhile, the X-3B removal efficiency in double-anode MFC was 19.81% higher compared with a single-anode condition when the X-3B was 1000 mg/L. The degradation pathway analysis indicated that aromatic amines formation and further oxidation were achieved sequentially in the MFC. Furthermore, microbial communities in the lower and upper anodes were analyzed, revealing that the microorganisms in the lower anode were more inclined to degrade the pollutant, whereas those in the upper anode were more inclined to generate electricity. This double-anode structure showed the potential for large concentration range of azo dye removal and the current recovery in real textile wastewater.

Removal of Cu and Zn from Aqueous Solutions by Selected Tree Leaves with Phytoremediation Potential Abstract In this study, some different selected plant leaves grown in Jordan such as Citrus limon (Rutaceae), Ceratonia siliqua L., Olea europaea (Oleaceae), Washingtonia filifera, and Myoporum (Myoporaceae) were examined for removal of copper (Cu) and zinc (Zn) ions from aqueous solutions. Cu and Zn were analyzed by atomic absorption spectrometry. A pH S-2 acidometer was used for determining the acidity of leaves solution system. Our findings showed the plants leaves were relatively efficient for removal of Cu and Zn compared to activated carbon. Removal of a 5 mg/L aqueous metal solution of Cu and Zn was treated with 2.5 g oven-dried plant in a 50 mL deionized water. The removal of Cu and Zn was expressed in terms of a time function ranged between 0 and 192 hours of contact time. The uptake of Cu and Zn by plant leaves was arranged in the following order: Cu: Activated carbon > Washingtonia filifera > Ceratonia siliqua L. > Olea europaea (Oleaceae) > Myoporum (Myoporaceae) > Citrus limon (Rutaceae) Zn: Activated carbon > Olea europaea (Oleaceae) > Citrus limon (Rutaceae) > Ceratonia siliqua L. > Washingtonia filifera > Myoporum (Myoporaceae)